Related Manuals for CEM FC-35
Summary of Contents for CEM FC-35
- Page 1 AC Clamp Meter AC Clamp Meter User Manual User Manual Please read this manual before switching the unit on. Important safety information inside.
- Page 2 AC Clamp Meter User Manual...
-
Page 3: Table Of Contents
AC Clamp Meter User Manual Contents Page 1.Safety...................... Description ....................3.Specifications ..................4.Operation....................4-1.AC Current Measurements..............4-2.AC/DC Voltage Measurements............4-3.Resistance and Continuity Measurements.......... 4-4.Diode Measurements................. 4-5.MAX Hold..................4-6.Backlight................... 4-7.Battery Replacement................ -
Page 4: Safety
AC Clamp Meter User Manual 1.Safety International Safety Symbols This symbol, adjacent to another symbol or terminal, indicates the user must refer to the manual for further information. This symbol, adjacent to a terminal, indicates that, under normal use, hazardous voltages may be present Double insulation Safety Notes... -
Page 5: Description
AC Clamp Meter User Manual be used to ensure that the terminals are not "live". •If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired. Input Limits Function Maximum Input A AC 200A... -
Page 6: Specifications
AC Clamp Meter User Manual Display Description AC DC AC (alternating current) and DC AUTO MAX HOLD AC DC (direct currrent) Minus sign 1.8.8.8 2000 count (0 to 1999) AC DC measurement reading AUTO AutoRange mode MAX Hold mode Diode test mode Audible Continuity HOLD Data Hold mode... - Page 7 AC Clamp Meter User Manual Clamp size Opening 0.7" (18mm) approx Diode Test Test current of 0.3mA typical; Open circuit voltage 1.5V DC typical. Continuity Check Threshold <120 ; Test current < 1mA Ω Low Battery Indication “BAT” is displayed Overrange Indication “OL”...
-
Page 8: Operation
AC Clamp Meter User Manual 4.Operation NOTICES: Read and understand all warning and precaution statements listed NOTICES: in the safety section of this operation manual prior to using this NOTICES: meter. Set the function select switch to the OFF position when the NOTICES: meter is not in use. -
Page 9: 4-2.Ac/Dc Voltage Measurements
AC Clamp Meter User Manual 4-2.AC/DC Voltage Measurements 1.Insert the black test lead into the negative terminal and the red test lead into the positive V terminal. 2.Set the function switch to the position. 3.Select AC or DC with the MODE button. -
Page 10: 4-5.Max Hold
AC Clamp Meter User Manual 4-5.MAX Hold To hold the highest reading on the LCD, press the MAX hold button. The MAX hold button is located on the left side of the meter (bottom button). The meter reading will not change as readings change, rather it will only display the highest reading encountered since the MAX hold button was pressed. - Page 11 AC Clamp Meter User Manual...
- Page 12 AC Clamp Meter User Manual...