HP xw4100 Hardware Installation Manual page 3

5. Push the drive into the selected bay until it snaps into place. Then attach the power and data cable to
the drive.
NOTE: For an HP Workstation xw4200, install two 6-32 screws into each side of the hard drive before
sliding the hard drive into the bay.
NOTE: If installing a hard drive into bay 5, lay the workstation on its side and remove the three drive
screws that are located near bay 5. Insert the drive into bay 5 and align the holes in the bottom of the hard
drive with the screw holes at the base of the chassis. Insert the screws through the base and tighten the hard
drive to the chassis.
The following image shows the xw8200 loaded with SCSI hard drives.
6. Connect the data cable to the SCSI1 connector on the system board (find it near the base of the
workstation or see the previous illustration).
If your workstation does not include a SCSI connector on the system board, you need to install a SCSI
controller card. Refer to the next section for additional instructions.
7. Replace the front bezel, access panel, reconnect any peripheral devices, and reconnect power.
3