Related Manuals for Eachine E120
Summary of Contents for Eachine E120
- Page 1 User Manual E120 Company: Lotus NL B.V. Address: Koningin Julianaplein 10, 1e Verd, 2595AA, The Hague, Netherlands. E-mail: peter@lotusnl.com Tel: +31644168999...
-
Page 2: Important Note
Important Note Warning And The Guide Of Using Battery Please read the manual to learn the function of the this product before operation. Damage to the product and potential personal injury may occur if you make an operational error. This is a RC helicopter, not a toy. You should not only have a prudent operation, but also to have an operational basis. -
Page 3: Packaging List
Helicopter paramenters Introduction of transmitter function Length 235 mm Height 80 mm Weight Propeller Length 256 mm Power Indicator Battery Specification 350mAh One key take off Flight Time About 15 min One key landing (Press this button, meanwhile Main Motor 1020 Speed turn on the TX power, to change... - Page 4 Batteries Charging Method Installation method of remote controller battery Blue light ladder flashes while Transmitter charging Charging method 1 Fully charged, four lights on Charging battery by the USB port on a computer. Description: Push 1. Connect the USB charger with USB port. 2.
- Page 5 Elevator Corresponding to step 2 Elevator up forward Elevator down backward Note: The direction of the battery Card buckle Aileron Forward flight Keep a safe distance of more than 2 meters Aileron left Left Aileron right Right Note: Beginner should pay attention to the direction of flight. Keep the head forward to avoid causing injury .
- Page 6 Commonly used parts replacement instructions Trimming Notes Remove the propeller with a hex wrench, Be careful not to be too tight when installing the new propeller Warning Maintain a flying altitude above one meter Introduction of the corresponding socket of receiver Main motor Optical flow localization Unplug the plug, then twist the motor...
- Page 7 Abnormal Problem Solving Method Problem Possible Cause Solution The helicopter without bind Bind the transmitter again Chopper power on. Taillight on with the transmitter. Blinking, no response to operation. Check the power supply of Check the installation site of After turning on the chopper helicopter and transmitter;...