Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Eachine E150
Summary of Contents for Eachine E150
- Page 1 User Manual E150...
-
Page 2: Table Of Contents
Table of Catalog Introduction Item List Notice Warning Additional Safety Precautions and Warnings Helicopter Parameters Warning and the Guide of Battery Usage Battery Charging Notice Before Flight Bind With Transmitter Throttle Curve and Pitch Curve Initial Flight Receiver Interface Diagram About the Transmitter Flight Battery Installment Troubleshooting... -
Page 3: Introduction
For up-to-date product literature, please visit can supply strong power and keep stability. Using the latest technology of new www.eachine.com. gyro type, this helicopter is compatible with 3D and 6G modes. You can make a variety of stunts in 3D mode. -
Page 4: Warning
Helicopter Parameters Warning 1.For maximum safety, please monitor the battery while charging. Length 330 mm 2.Please do not allow children to carry out the charging by themselves but ensure Height 105mm adult supervision at all times. Weight 181g 3.Please use the original standard charger of this product for charging. The use of Length of Main Propeller 355 mm unknown charger may pose risks of fire and explosion. -
Page 5: Throttle Curve And Pitch Curve
Initial Flight Notice： If you are not familiar with the controls of the E150, please take a few minutes to get 1.When the transmitter is turned on and the throttle hold switch is in the ON position, familiar with them and then try your first flight. -
Page 6: About The Transmitter
About the Transmitter Flight Battery Installment 1)Debugging pitch of thread Explanation: The product has passed the inspection before leaving the factory, the user needs tore-adjust the pitch of thread after replacing the steering gear 6CH/IDLE Switch or related accessories. To ensure safety, disconnect the main motor power cord during commissioning to avoid personalinjury caused by motor rotation during commissioning. -
Page 7: Troubleshooting
Troubleshooting Exploded View Problem Cause Solution LED on receiver flashes constantly Transmitter is not bound to receiver. Re-pair (Refer to P.5, Programming with no responses after connecting Pairing of the transmitter and receiver your Transmitter). batteries to transmitter. failed. Servo #2 Check whether the transmitter and Open the transmitter, make sure the receiver connecting to power;... -
Page 8: Accessory List
Accessory List Accessories List Part No: 2.32.01.E150-001 Part No: 2.32.01.E150-002 Part No: 2.32.01.E150-003 Part No: 2.32.01.E150-004 PARA NAME QUANTITY Part Name: Main Grip Blade Part Name: Main Rotor Head Part Name: Main Blade Grip Set Part Name: Main Blade Set...