Installing The Optional Egram Module - HP Visualize b132L Upgrade Instructions

Transfer the Optional EGRAM Module from the Old Main Tray to the New Main Tray
4 Install the standoffs into the two holes on the new main tray assembly, as shown
Figure 9

Installing the Optional EGRAM Module

5 Line up the connector on the EGRAM module and the connector on the new main
6 Connect the EGRAM board to the new main tray assembly. Press down firmly on
16
in Figure 9.
tray assembly while at the same time aligning the standoffs to the holes in the
EGRAM module., as shown in Figure 9.
the connector area and near the standoffs to make sure that the module is fully
seated and that the standoffs are fully engaged with the EGRAM module.