HP Visualize B1000 Install Manual page 8

Introduction
The HP Visualize fxe card is an entry level, 2D/3D graphics card (32-bit,
33 MHz) with 16 Mbytes of SGRAM. It provides analog video only
through a standard 15-pin miniature D-sub connector.
The HP Visualize fx
graphics card. The fx
accelerator ASIC and a single ASIC for rastering and texturing.
The HP Visualize fx
graphics card. The fx
and a single rastering and texturing ASIC
The HP Visualize fx
high-end graphics card. The fx
dual geometry accelerator ASIC's, and a single rastering and texturing
ASIC.
All fx family graphics cards require a PCI 2X interface to the HP-UX
workstation backplane.
This manual also describes the basic prerequisites for installing HP
Visualize fx graphics cards into the supported workstations. The table
below lists the various graphics products covered by this manual, and
their respective product numbers.
Table 1-1
Product Number
A4982A
A1262A
A1299A
A1299B
8
5
2D/3D graphics accelerator card is a mid-level
5
Pro features 64MB of SDRAM, a single geometry
10a
2D/3D graphics accelerator card is an high-end
10a
Pro features dual geometry accelerator ASIC's,
10b
2D/3D graphics accelerator card is also an
10b
Pro features 128 Mbytes of DDR RAM,
Supported Graphics Products
Product Description
HP Visualize fxe
5
HP Visualize fx
10a
HP Visualize fx
10b
HP Visualize fx
Chapter 1