If An Accessory Board Does Not Work - HP Vectra XA5 User Manual

CD-ROM Drive Does Not Work
Check that the cables have been properly connected.
•
Check that a CD is inserted in the drive.
•
Verify that the CD-ROM is declared as "CD" in the Setup program
•
(refer to "IDE Devices Submenu (Configuration group)", on page
48).
Verify that the
•
Bus IDE Adapters
(refer to "IDE Devices Submenu (Configuration group)", on page
48).
If you intend to boot on CD-ROM, make sure that this option is
•
enabled in Setup (refer to "Start-up Center Submenu (Security
group)", on page 54).
For further information refer to the CD-ROM documentation.
•
CD-ROM Drive is Idle
If the CD-ROM drive does not appear to be working, try accessing the
disk by clicking on the CD-ROM drive icon or drive letter assigned to
the CD-ROM drive by your operating system.

If an Accessory Board Does Not Work

Carry out the following checks:
Ensure the board has been firmly installed in the accessory board
•
slot.
Check that the accessory board has been correctly configured with
•
the ISA Configuration Utility if necessary.
Ensure the board is not using memory, I/O addresses, an IRQ, or
•
DMA also used by the PC. Refer to "IRQs, DMAs, and I/O Addresses
Used by Your PC", on page 83. Refer to the board's manual for further
details.
Check that the PC has been configured correctly in Setup.
•
If the problem persists, refer to HP support.
•
4 Troubleshooting Your PC
If Your PC Has a Hardware Problem
item is set to
Both
in Setup
English 75