If You Cannot Start Your Pc From A Modem; If A Post Error Message Is Displayed - HP Vectra XA5 User Manual

If You Cannot Start Your PC from a Modem

If you are running Windows 95 and you have chosen the option to start
your PC from a modem, and this option does not work, then you need
to change the IRQ setting in the HP Setup program.
In the Setup program, go to the Security group, and the "Start-up
Center" submenu. Change the IRQ setting for the setup item "Start
from Modem". (Refer to "Start-up Center Submenu (Security group)",
on page 54.)

If a POST Error Message is Displayed

The Power-On-System-Test (POST) can detect both an error and a
change to the configuration
description is displayed. Depending on the kind of error, you will have
one or more of these choices available on screen:
Press to ignore the message and continue.
•
Press to run Setup and correct a system configuration error. HP
•
recommends that you correct the error before proceeding, even if
the PC appears to start successfully.
Press to accept (validate) the change and update Setup's
•
configuration information.
Press to see more details about the message. After viewing
•
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press
configuration information. Otherwise, press
message and continue, or press
system configuration error. (The number of choices you will have
available are dependent on the kind of error.)
1. If you add a device, no POST error message is displayed. If you
remove a device, or Setup cannot find a device, a POST error message
will be displayed.
1
. In either case, an error code and short
to accept the change and update Setup's
to run Setup and correct a
4 Troubleshooting Your PC
If Your PC Does Not Start Properly
to ignore the
English 67