HP Vectra VL5 5 User Manual page 34

NOTE
2 How to Install Accessories In Your PC
Installing Memory
To install a main memory module:
1 Disconnect the computer's power supply cord and any connection to
a telecommunications network.
2 Remove the computer's cover and the power supply (refer to page
20).
3 Align the memory module with the slot, with the notch on the right
hand side. For each memory module, slide it into the slot at 45°.
Pivot the memory module to a perpendicular position and click into
place.
The letters "A", "B", and "C" are used for reference only in the above
illustration. These letters do not appear on the system board. The bank
identified here as "C" is the one closest to the processor.
4 If you need to remove a main memory module, release the retaining
clip and pull the module forward and out of the socket.
5 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
6 Check the HP Summary Screen to verify the new configuration.
Refer to page 66.
22 English