Installing A Bnc Coax Adapter - HP Vectra VL5 5 User Manual

2 How to Install Accessories In Your PC

Installing a BNC Coax Adapter

Installing a BNC Coax Adapter
If your PC is supplied with an pre-installed network board with a UTP
(Unshielded Twisted Pair) connector, you can install a BNC Coax
connector onto this board. Order HP part number D3979A.
Follow this procedure to install a coax adapter connector:
1 Disconnect the PC's power supply cord and any connection to a
telecommunications network.
2 Remove the PC's cover.
3 From inside the PC, push out and remove the metal plug on the
network board to expose the hole for the coax connector.
4 Remove the nut from the coax connector.
5 Attach the coax adapter board to the network board and at the same
time insert the coax connector through the hole in the network
board's back metal plate.
6 From outside the PC, screw the nut back onto the coax connector
until it is secured tightly on the network board.
7 Replace the PC's cover.
8 Reconnect all cables and then the power supply cord.
38 English
Network Board
BNC Coax Connector
Installed Here