Connecting To A Windows Nt 4.0 Server - HP Vectra VE6 8 Installation Manual

4 Connecting to a Windows NT 4.0 Server

Windows for Requirements
Workgroups
• HP Vectra with Windows for Workgroups 3.11 installed.
• IBM Token-Ring 16/4 PCI adapter and drivers CD ver 1.2
• Driver Name for Vectra VL8: IBMTRP.386 Size: 78K Date: 5/21/96
• Driver Name for Vectra VE7/VE8: IBMTRPO.SYS Size 71K Date: 7/21/97.
• Microsoft Windows NT 4.0 Server that supports Net BEUI, NWLink IPX/
Device Configuration
Card State
I/O Address
Procedure
1 With the HP Vectra turned off, install the IBM 16/4 PCI TR adapter card
2 Power on the machine and boot to Windows 3.11.
3 After Windows loads, open the "NETWORK" folder, and double-click the
4 Select "Networks" and choose "Install Microsoft Windows Network" and
5 Click on "Drivers" then on "Add Adapter."
6 With "Unlisted or Updated Network Adapter", click on "OK."
7 Insert the IBM Token-Ring PCI WOL drivers CD, set the path to "D:\"
SPX, and NWLink NetBIOS transfer protocols.
Vectra VL8
-
Interrupt 11
C800-h
into a PCI slot.
"NETWORK SETUP" icon.
click on "OK."
(Where "D" is the drive letter assigned to your CD-ROM) and click "OK."
(If you have an HP preloaded HDD, set the path to "C:\MASTERS\LAN
\TRPCI.WOL\")
4 Connecting to a Windows NT 4.0 Server
Vectra VE7/VE8
Enabled
10
DC00-h
Windows for Workgroups