Table of Contents
Advertisement
COMPONENT LIST
1.
BLADE
2.
PIVOTING BLADE FOOT
3.
TOOL-LESS BLADE CLAMP SLOT
4.
LED LIGHT
5.
PENDULUM SELECTOR KNOB
6.
LOCK-OFF BUTTON
7.
ON/OFF TRIGGER SWITCH
8.
BATTERY PACK *
9.
BATTERY PACK RELEASE BUTTON *
10. TOOL-LESS BLADE CLAMP LEVER
FOOTPLATE DEPTH ADJUSTMENT
11.
BUTTON
* Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type KUE01 KUE01.9 (E01-designation of
machinery, representative of Reciprocating Saw)
10
Voltage
No load speed
Load speed
Stroke length
Wood
Cutting
capacity
Steel
Machine Weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
ACCESSORIES
Battery pack
Charger
Wood cutting saw blade
Metal saw blade
Bit clip
Lithium-Ion Brushless Reciprocating Saw
KUE01
KUE01.9
20V
Max**
0-1400/min
0-3000/min
29mm
300mm
12mm
3.15kg
2.5kg
KUE01
KUE01.9
2 (KAB21)
/
1 (KAC21)
/
1
1
1
1
1
1
KUE01 KUE01.9
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on the
workpiece. It is suitable for straight and curved cuts.
ASSEMBLY AND OPERATION
ACTION
Tool-Less Blade Fitting
On/Off Operation
NOTE: LED light will illuminate the
working zone automatically when the
product is switched on.
NOTE: Your saw is equipped with
a lock-off button. Press the lock-off
button to lock the trigger switch.
Always lock the trigger switch when
carrying or storing the machine.
Variable Speed Control
HAND GRIP AREAS
FOOTPLATE ADJUSTMENT
NOTE: Adjust the position of footplate
according to the blade length and
workpiece thickness; always ensure
that the blade extends beyond the
workpiece throughout the stroke.
PENDULUM SELECTOR KNOB
Adjust the pendulum speed according
to the workpiece material and thickness.
OFF position: Fine cuts in thin
workpieces; cutting surface quality
is more preferred than speed; cutting
metal.
ON position: Fast cuts in soft materials
(e.g. softwood); cutting in the direction
of the wood grain.
Flush Cutting
Wood Cutting
Metal Cutting
Plastic / Aluminum Cutting
Pocket Cutting (Soft Materials Only)
FIGURE
See Fig. A
See Fig. B1
See Fig. B2
See Fig. C
See Fig. D1,
D2, D3
See Fig. E
See Fig. F, G
See Fig. H
See Fig. I
See Fig. J
See Fig. K
Advertisement
Table of Contents
