Download Print this page
KRESS KU420 Safety And Operating Manual
KRESS KU420 Safety And Operating Manual

KRESS KU420 Safety And Operating Manual

Hide thumbs Also See for KU420:

Advertisement

Quick Links

SAFETY AND OPERATING MANUAL
Circular Saw
KU420

Advertisement

loading
Need help?

Need help?

Do you have a question about the KU420 and is the answer not in the manual?

Questions and answers

Summary of Contents for KRESS KU420

  • Page 1 SAFETY AND OPERATING MANUAL Circular Saw KU420...
  • Page 3 Check for misalignment or binding of power tool. Do not use a power tool while moving parts, breakage of parts and any you are tired or under the influence of other condition that may affect the power Circular Saw KU420...
  • Page 4 Do not use dull or damaged blades. holes. Blades that do not match the mounting Unsharpened or improperly set blades produce hardware of the saw will run off-centre, causing narrow kerf causing excessive friction, blade loss of control. binding and kickback. Circular Saw KU420...
  • Page 5 ADDITIONAL SAFETY RULES FOR YOUR CIRCULAR SAW Only use saw blades recommended in the specification. Do not use any abrasive wheels. Use only blade diameter(s) in accordance with the Circular Saw KU420...
  • Page 6 Circular Saw KU420...
  • Page 7 Incorrect Correct Circular Saw KU420...
  • Page 8 Circular Saw KU420...
  • Page 9: Component List

    COMPONENT LIST TECHNICAL DATA Type KU420 (4 - designation of Safety on/off switch machinery, representative of circular saw) Fixed guard Base plate Rated voltage 220-230V~50Hz Movable guard Rated input power 1400W Movable guard lever Rated no load Saw blade 5200r/min...
  • Page 10 (Fig. Lift the depth adjustment knob up to raise the body away from the base plate. Set the cutting depth using the scale then push the depth locking knob Circular Saw KU420...
  • Page 11: Working Hints For Your Circular Saw

    MAINTENANCE Your power tool requires no additional lubrication or maintenance. There is no parts requiring special maintenance Only simple maintenance on the machine is needed according to the following Circular Saw KU420...
  • Page 12 Copyright © 2019, Positec. All Rights Reserved.