In order to keep the pump in full efficiency (only mechanical part), every 3/6 months as an
OPTIONAL
maintenance, it is advisable to perform a shot for few seconds (with the fluid or
with water) activating it through the alarm control panel.
As an
ANNUAL
maintenance, is prescribed to:
1. Replace the backup batteries (1x12V 1.3A if DT-POWER200 has been installed on the
device)
2. Disconnect the 230V from the appliance, open the burner contact compartment
3. Check the state of health of the 230V power supply cables of the burner and the safety
thermostat.
4. Check that the safety thermostat is still perfectly adherent to the burner.
5. Measure the electric absorption on the 230V, it must be almost ZERO from disarmed and
Max. 3 Ampere from armed
6. Perform a full supply (it can be done using water but it is advisable to use the fog generator
liquid)
Repeat the operation if the steam generated emits a burning smell
7. Replace or top up the DEFENDERTECH liquid tank
8. Reset the Liquid Level by removing the "L" Jumper for 3 seconds
If NON-CONFORMITY has been detected in
3 - 4 – 6 points immediately turn off the power and
contact the DefenderTech Service.
Manutenzione
WARNING!!!
~ 13 ~
.
Need help?
Do you have a question about the DT-200Turbo and is the answer not in the manual?