Assembly - Jaypro CARBON ULTRALITE Installation And Operating Instructions Manual

PVB-9500 Jaypro Carbon Ultralite 3" OD Net System Instructions
6

Assembly

1. Install each upright into the ground sleeves.
* The bottom 10 inches of the standards have been covered with an outer layer to
improve fit in most ground sleeves. If fit is too tight, cut outer layer with knife and
remove.
2. Follow instructions included with winch to set the winch clamp to the correct
upright diameter (3").
3. Install winch to one upright using the socket cap screw and acorn nut (
6-1
, items 1 & 2).
4. Fasten the clamp together using the cap screws supplied with the winch (
6-1
, item 4-1).
Figure 6-1: Winch installation.
- 6 of 9-
Figure
Figure
UPDATED 12/12/2018