Table of Contents
Advertisement
2G Alarm Communicator Installlation Manual
R
ATINGS
Table 3: Communictor Electrical Ratings
Model
Power Supply Ratings
Input Voltage
Current Consumption
Standby Current (@ 3.7V)
Alarm (Transmitting) Current)
Antenna Specifications
Dual band Antenna
Environmental Specifications
Operating Temperature
Humidity
Mechanical Specifications
Board Dimensions (mm)
Weight (grams)
H
C
ARDWARE
OMPATIBILITY
Table 4: Compatibility
Receiver/
Communicator
ControlPanel
GS2055
Receiver
TL255GS
Control Panel
Note for ULC Listed installations:
Products or components of products, which perform communications functions only, shall comply with the requirements applicable to
communications equipment as specified in CAN/CSA-C22.2 No. 950-1, Information Technology Equipment-Safety - Part 1: General
Requirements. Where network interfaces, such as the following, are internal to the subscriber control unit or receiver, compliance to
CAN/CSA-C22.2 No. 950-1 is adequate. Such components include, but are not limited to: Hubs; Routers; Network interface devices;
Third party communications service providers; Digital subscriber line (DSL) modems; and Cable modems.
Note for UL Listed installations:
Packet switched data network interface equipment, manufactured by other than the burglar alarm equipment manufacturer, that is not
required for the processing of the signals shall be evaluated to the applicable requirements of the Standard for Information Technology
Equipment – Safety – Part 1: General Requirements, UL 60950-1, either as burglar alarm equipment or communication equipment.
S
C
OFTWARE
OMPATABILITY
The Communicator is compatible with the following software:
• Connect24 Using: Simple Messaging System (SMS) Protocol.
• Connect24 Remote Flash. Using: Internet Protocol (IP) using Trivial File Transfer Protocol (TFTP).
C
OMMUNICATOR
1
C
24™
A
ONNECT
CCOUNT AND
(Before Installation)
Installation of the Communicator requires activation with Connect24 before operation. Dealer application forms and additional infor-
mation on the Connect24 Voice Response Unit (VRU) and graphical user interface (GUI) can be found at http://www.Connect24.com
or by telephone at: USA 1-888-251-7458 or CANADA 1-888-955-5583.
IMPORTANT: Prior to installing a GS2055 or TL255GS Communicator, contact your monitoring station to determine if it is a master
re-seller or visit http://www.Connect24.com to become an authorized dealer. In either instance, you will require a Profile Number,
Installer ID Number, and an Installer Password. Perform the following pre installation:
1. Retrieve the installer account and password from the master reseller, or from Connect24 directly.
2. Connect your browser to the Connect 24 website at: http://www.Connect24.com or call VRU number 1-866-910-3865.
3. Follow the voice prompts to enter the required account information.
4. Perform the following steps in a Connect24 session to activate the SIM card and initialize programming:
a. Navigate to the Initialize an account section.
b. Select Profile (This information will be provided by the master reseller or by Connect24).
c. Select Product Module.
d. Enter the SIM card number.
e. Click Next then enter in all relevant information as required.
f. Confirm all information is entered correctly before submitting.
5. Repeat Step 4 to program another SIM card (i.e. another Subscriber), or log out from Connect24.
1. Connect24, DSC, and DLS IV are Registered Trademarks of Tyco International Ltd. and its respective Companies. All Rights Reserved.
GS2055
Cellular Only
3.5 / 3.9 / 4.2 VDC (min / NOM / MAX) from the SCW9055/SCW9057 panel
75 mA
75 mA
400 mA @ 3.7V during transmission
0°C - 49°C (32°F- 120°F)
5% ~ 85% relative humidity, non-condensing
60
Description
SG System I, v1.14+
SG System II, v2.11+
SG-DRL3-IP, v2.3+
SG-DRL4-IP, v1.2+
SCW9055/SCW9057 V1.00
P
I
RE
NSTALLATION
SIM
A
CARD
CTIVATION
firealarmresources.com
TL255GS
Ethernet and Cellular
100 mA
100 mA
See Table 2
109 x 110
65
C
ONFIGURATION
Ratings
7
Advertisement
Table of Contents
