Attaching The Lid Handles; Mounting The Accessory Tray - Louisiana Grills LG800D Assembly And Operation Manual

7. ATTACHING THE LID HANDLES

Parts Required:
4 x Handle Bezel (#5)
Hopper Lid Handle (#6)
1 x
1 x Lid Handle (#7)
Installation:
• Remove the two pre-installed screws from the hopper handle. From
inside the hopper lid, insert one screw so that it protrudes to the
outside. Add a bezel on the screw, then hand-tighten the screw (from
the inside) into the hopper lid handle. Repeat same installation for
other end of hopper lid handle.
• Remove the two pre-installed screws from the lid handle. From inside
the barrel lid, insert one screw so that it protrudes to the outside. Add
a bezel on the screw, then hand-tighten the screw (from the inside) into
the lid handle. Repeat same installation for other end of lid handle.
NOTE: Do not over-tighten screws. Only a snug fit is necessary.

8. MOUNTING THE ACCESSORY TRAY

Parts Required:
1 x Accessory Tray (#11)
2 x Screw (#B)
Screw (#D)
2 x
Installation:
• First, locate the spade connector from the inside of the small opening
on the front panel of the main grill. Connect the spade connector
from the main grill to the spade connector of the accessory tray. Note
illustration 8A.
IMPORTANT: Failure to connect the spade connectors will result in no
power to the digital controller. Ensure a proper connection is made
before securing the accessory tray to the main grill.
• Secure the top two corners of the accessory tray to the front of the
grill using one screw (#D) in each corner. To secure the bottom, insert
a screwdriver into the holes provided and secure the other two screws
(#B) . Note illustration 8B for proper screw placement.
NOTE: Avoid storing items in the tray for long periods of time, as the
accessory tray will become warm when using the grill and may cause
some items to melt.
10
7
6
5
5
5
8A
8B
11
D
B
7
5
D
B