Table of Contents
Advertisement
Connect with Synology NAS
RX6022sas supports multipath I/O for better stability and performance. This section will guide you through how to
connect the expansion units to your Synology NAS. Please follow our instructions below strictly to avoid system
error.
Note:
• RX6022sas comes with two SAS expansion cables (100cm and 200cm). Please use the longer one to
connect the farthest expansion unit to your Synology NAS.
• The primary and secondary ports on the back of the HD6500 are marked by stickers.
To connect RX6022sas with HD6500
1 Connect one end of the expansion cable to the primary port of your HD6500 and the other to the expansion
port of RX6022sas. Make sure the release band of the cable faces rightward when plugging into the HD6500,
and that of the cable faces upward when plugging into RX6022sas; otherwise, the HD6500 and expansion unit
will not be correctly connected.
1 For 1 HD6500 and 1 RX6022sas:
22 Chapter 2: Hardware Setup
HD6500
RX6022sas
Advertisement
Table of Contents
