Position And Level The Washer - Alliance Laundry Systems TR7104WN Installation Instructions Manual

1
1. Beaded Strap (tape if necessary)

Position and Level the Washer

1. Position washer so it has sufficient clearance for installation
and servicing.
2. Place washer in position on a clean, dry, and reasonably firm
floor. Installing the washer on any type of carpeting is not rec-
ommended.
3. For easier access to leveling legs, prop up washer with a
wooden block.
1
1. Wood Block
4. Place rubber cups (from accessories bag) on all four leveling
legs.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
TLW2284N_SVG
Figure 8
TLW2285N_SVG
Figure 9
1
5
4
1. Level
2. Locknut
3. Leveling Leg
4. Rubber Cup
5. Washer Base
5. Place a level on the cabinet top and check if the washer is lev-
el from side to side and front to back.
6. If washer is not level, tilt washer back to access the front lev-
eling legs. Loosen the locknuts and adjust legs by screwing
into or out of washer base.
7. Once adjusted, tilt the washer forward on front legs and lower
back down into position to set the rear self-leveling legs.
8. Washer must not rock. When washer is level and does not
rock, tighten locknuts securely against bottom of washer base.
If these locknuts are not tight, washer will not remain station-
ary during operation.
Improper installation or flexing of weak floor will cause exces-
sive vibration.
Do not slide washer across floor once the leveling legs have been
extended, as legs and base could become damaged.
9. Verify that unit does not rock.
9
Installation
2
3
TLW2286N_SVG
Figure 10
Part No. 204300ENR3