Replacement Of Arm Assembly - Panasonic SC-HC395EG Service Manual

8.14.3. Disassembly of Motor Assembly
• Refer to "Refer to (Step 1) of item 8.14.1."
Step 1 : Desolder pins on solder side of Motor P.C.B..
Step 2 : Release 2P wire from slot.
Step 3 : Release catches.
Step 4 : Remove Motor Assembly.
Caution : During assembling, position & align Motor wire
with the guide on Gear Base, A "click" sound is heard
when Motor is fully catched.

8.15. Replacement of Arm Assembly

• Refer to "Disassembly of Front Ornament Unit (L) & (R)"
• Refer to "Disassembly of Door Unit"
• Refer to "Disassembly of Front Panel Block"
• Refer to "Disassembly of Gear Block & Arm Spring (Top)"
• Refer to "Disassembly of Arm Spring, Gear Assembly & Arm
Assembly"
8.15.1. Disassembly of Drive Gear, Door
Holder & Gear Shaft
Step 1 : Release and push Door Holder to the middle of Gear
Shaft.
Caution : During assembling, ensure Door Holder is in lock
position as shown.
Step 2 : Push Door Arm Bottom and Door Arm Top to release
guide and remove Gear Shaft Assembly.
29