Canon varioPRINT 135 Series Operation Manual page 250

Illustration
[49] The Copy/Scan view on the control panel
Usage
You can use the scan-to-email, scan-to-file and scan-to-SMB templates through the [Copy/Scan]
section on the control panel ([Jobs] -> [Copy/Scan]. To scan a document, select the required
template. Next, the job window opens. There you can change a number of settings for this scan
job. However, these changes are only valid for this job. The default settings of the scan template
will not change.
The scan-to-USB function is accessible through the USB button in the [Jobs] section on the
control panel. The left-hand side of the control panel contains the slot for the USB flash drive.
The scan-to-DocBox function is accessible through the [To DocBox] tile in the [Copy/Scan]
section.
Removal of Scan Jobs
The PRISMAsync controller buffers the scan jobs until the jobs are delivered to the specified
output location. You can remove scan jobs from the buffer manually or automatically.
• Manually via the printer control panel: Touch [Jobs] -> list of [Scan jobs] -> select a scan job ->
touch [Delete].
• Manually via the Settings Editor: Access the Settings Editor -> click [Support] ->
[Troubleshooting] -> [Clean the scan job export buffer].
• Automatically: The PRISMAsync controller removes a buffered scan job automatically 48 hours
after a scan job has finished.
Canon varioPRINT 135 Series
Introduction to the Scan Function
Chapter 8 - Carry Out Scan Jobs 249