Canon VarioPrint 6000 Series Operation Manual page 295

Group of settings
[Remote connection]
(optional)
[System settings]
Procedure
NOTE
You need to have access rights to make changes in this section.
1. Touch [System] -> [Setup] -> [System configuration] (below the [Advanced] bar).
2. Touch the button of the group that contains the setting you want to change or view.
3. Touch the required setting.
4. Look up the required information or make the required changes.
5. If you make a change, touch [OK] to confirm.
6. Press [Close].
VarioPrint 6000 line
Change a number of settings in the Settings Editor via the control panel
Available settings
• [Remote connection
status] (read-only)
• [Remote connection
enabled]
• [ID of Service org.
(SOID)]
• [Test remote con-
nection]
• [Date and time]
• [System of meas-
urement]
• [Media weight]
• [Time zone]
• [Show install wiz-
ard after next start-
up]
Short description
The [Remote connection] section (optional)
contains the settings to enable the remote con-
nection and to configure the Remote Service.
NOTE
Only Service can adapt the remote
connection settings. After Service
adapts the remote connection set-
tings, you can test the remote con-
nection with this setting.
The [System settings] section contains a/o set-
tings to change the date and time of the sys-
tem, or the system of measurement used.
When you change the system of measure-
ment, all corresponding values on the system
will be changed. For example, when you
change [Metric] into [Imperial], all length val-
ues will be displayed in inches. You can also
indicate how the media weight is displayed.
Chapter 12 - Maintain the print system 295