Zanussi ZGG35214 User Manual page 13

To replace the connection cable use
only H03V2V2-F T90 or equivalent
type. Make sure that the cable
section is applicable to the voltage
load and the working temperature.
The yellow/green earth wire (B)
must be approximately 2 cm longer
than the live and neutral wire (A).
1. Connect the green and yellow (earth) wire
to the terminal which is marked with the
letter 'E', or the earth symbol
coloured green and yellow.
2. Connect the blue (neutral) wire to the
terminal which is marked with the letter 'N'
or coloured blue.
3. Connect the brown (live) wire to the
terminal which is marked with the letter 'L'. It
must always be connected to the network
phase. There must be no cut or stray
strands of wire present. The cord clamp
must be correctly attached to the outer
sheath.
Assembly
1.
www.zanussi.com
A B
, or
2.
3.
min. 650 mm
40-50 mm
55 mm
30 mm
4.
50 mm
If a furniture unit is installed at a
distance of 400 mm above the
hob, there must be a minimum
safety distance of 50 mm to the
left or right from the edge of the
hob.
5.
490 mm
270 mm
400 mm
13