HP P Class 450/500/550/600/650/700/750 Reference Manual page 72

Interface Devices and Mass-Storage
SCSI/LAN Combo Board
10BT/100TX LAN Features
Table 3-3. 10BT/100TX LAN Features
Feature:
LAN Controller
RJ45 Connector
Remote Boot
ExtStart Connector
Remote Power On
Remote Wake Up
Remote Power On
Remote Power On (RPO) is available at 10 and 100 Mbits per second.
Vstandby Requirements for Supporting RPO
The Vstandby requirements for HP network cards supporting RPO, are:
A power supply able to deliver at least 250mA on Vstandby output. This is the case for
all HP V
ISUALIZE
Optional Bootrom Socket
It is possible to add a flash device on the network card socket with a specific LAN bootrom
code. This new bootrom code will be seen and mapped automatically by the system BIOS
instead of the embedded version (system BIOS).
NOTE At the time this TRM was produced, there was no flashing tool available to
allow you to update the bootrom content in the flash on the LAN adapter. A
flashing tool for any AMD-based card may be available, but in order to use
this tool on HP cards, only 29fxxx flash devices must be used. At present, no
test has been carried out using this tool on HP cards.
Flash / ROM Devices
The 10BT/100TX card provides a PLCC 32-pin socket and any size of flash device can be
used up to 256KB.
Installing Two LAN Remote Power On Cards
From a network standpoint, it is possible to install two LAN RPO cards, and both cards
will be functional (for example, from the operating system, it will be possible to have two
LAN cards up and running at the same time).
72
Drives
Description:
AMD PCNET-Fast chip
10BT/100TX autonegotiation
Protocols integrated in System BIOS
• Connection to CPU board
• LAN remote power on signals
• Full remote power on with Magic Packet
• Wake Up from Suspend state with Magic Packet
systems.
Chapter 3