Removing And Replacing The Cover; Replacing The Cover After Installing Accessories; Removing The Cover - HP Net Vectra Supplementary Manual

Hp net vectra: supplementary guide

Hide thumbs Also See for Net Vectra:

Table of Contents

Removing and Replacing the Cover

For your safety, never remove the PC's cover without first removing the power

WARNING

cord from the power outlet, and any connection to a telecommunications

network. After switching off the PC, please leave enough time for the heatsink

to cool down before opening the case. Always replace the cover on the PC

before switching it on again.

1 Switch off the display and computer.

2 Disconnect all power cables and any telecommunications cables.

3 If necessary, unlock the cover using the key on the side panel.

4 Lift the two latches on the rear of the computer upwards. Slide the cover

1 Ensure that you have installed all your accessories and that all internal

2 Slide the cover onto the computer, making sure that the two guides at the

3 If required, lock the cover using the key provided.

4 Reconnect all the power cables.

forwards and off the computer.

cables are properly connected and safely routed.

bottom of the case slide into the two rails at the base of the computer.

Firmly slide the cover backwards into position.

Removing and Replacing the Cover

Table of Contents