Table of Contents
Advertisement
Quick Links
620: UPHOLSTERED BLOOD-DRAW / PHLEBOTOMY CHAIR WITH PADDED
ARMS - ASSEMBLY AND OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions before assembling or using
the Blood-Draw / Phlebotomy Chair. If you do not understand any part of these warnings,
cautions or instructions, contact a healthcare professional for direction in the use of
this product. If the Blood-Draw / Phlebotomy Chair is not properly assembled and used,
personal injury and damage to the Blood-Draw / Phlebotomy Chair could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts. Use only Intensa replacement parts. Non-Intensa replacement parts
could cause personal injury and damage to the Blood-Draw / Phlebotomy Chair.
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate
(DEHP) which is known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.p65warnings.ca.gov/furniture.
WARNING: 620 Chair maximum weight capacity is 800 lb (363 kg), EVENLY DISTRIBUTED.
WARNING: Intensa, Inc. assumes no responsibility for any damage or injury caused by
improper installation or use of this product.
INTENDED USE
The Blood-Draw / Phlebotomy Chair is intended as a medical-room chair where a patient can sit
comfortably to allow medical personnel to draw blood.
UNPACKING
Check for any obvious damage to the carton or contents (after unpacking). If damage is evident,
immediately notify the carrier and Intensa.
Open the box and carefully remove the assembled frame and other components. Inside the box are:
1) One frame with seat and arm receivers attached and arms installed
2) One back
3) Four washers and four #10 x 2" Phillips flat head wood screws (to attach back to frame)
4) One Wireform Wallsaver, if ordered
IN_610-620-INS-LAB-RevC22
620 Blood-Draw / Phlebotomy Chair
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Graham Field intensa 620
Summary of Contents for Graham Field intensa 620
- Page 1 620: UPHOLSTERED BLOOD-DRAW / PHLEBOTOMY CHAIR WITH PADDED ARMS - ASSEMBLY AND OPERATION INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR FUTURE USE WARNING: Important! Read and understand these instructions before assembling or using the Blood-Draw / Phlebotomy Chair. If you do not understand any part of these warnings, cautions or instructions, contact a healthcare professional for direction in the use of this product.
- Page 2 CHAIR ASSEMBLY Tools required: Phillips screwdriver Attaching Back to Frame 1. Place the flat side of the back in position against the rail at rear of frame with curve upward, as shown at above left, centering the back evenly against the chair frame. Use provided wood screws to secure with back frame.
- Page 3 OPERATION WARNING: Ensure the Blood-Draw / Phlebotomy Chair is securely assembled as previously described before each use. Monitor patient to ensure Blood-Draw / Phlebotomy Chair does not adversely affect patient in any way. If so, discontinue use immediately. CARE AND MAINTENANCE Cleaning and Disinfection WARNING: Check the Blood-Draw / Phlebotomy Chair before each use for signs of damage.
- Page 4 LIMITED WARRANTY SCOPE OF WARRANTY Intensa, Inc. (“Intensa”) warrants to the original purchaser only that it will replace or repair components, at Intensa’s sole discretion, that are defective in material or workmanship under normal use and service. All warranties are conditioned upon the proper use of the products strictly in accordance with good commercial practice and applicable Intensa instructions and manuals, including proper use and maintenance.
Need help?
Do you have a question about the intensa 620 and is the answer not in the manual?
Questions and answers