Location Requirements - Whirlpool 7MWFC6820LW Owner's Manual

Available accessories:
An optional matching pedestal is available for your machine.
Please contact your retailer for ordering information, or see the
"Assistance or Service" on Quick Start Guide.
Alternate parts (not supplied with machine):
Your installation may require additional parts. To order, please
refer to toll-free numbers on Quick Start Guide.
If you have:
Overhead sewer
Alternate inlet hoses (may be required for some installations, not
supplied with machine):
� 8212656RP
� 8212641RP
� 8212546RP
� 8212545RP
� 8212487RP
� 8212638RP

Location Requirements

Proper installation is your responsibility.
You will need:
� A water heater set to 120°F (49°C).
� A grounded electrical outlet located within 6 ft (1.8 m) of power
cord on back of machine.
� Hot and cold water faucets located within 4 ft (1.2 m) of hot
and cold water fill valves on machine, and water pressure of
20 psi–100 psi (137.9 kPa–689.6 kPa).
� A level floor with maximum slope of 1" (25 mm) under entire
machine. Installing on carpet or surfaces with foam backing is
not recommended.
� Floor must support machine's total weight (with water and
load) of 315 lb (143 kg).
IMPORTANT: Do not install, store, or operate machine where it
will be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in machine after use may cause damage in low
temperatures. See "All-In-One Washer & Dryer Care" for
winterizing information.
10
You will need:
Standard 20 gallon (76 L) 39"
(990 mm) tall drain tub or utility
sink, sump pump and
connectors (available from local
plumbing suppliers)
10 ft (3.0 m) Inlet hose, Black
EPDM (2 pack)
5 ft (1.5 m) Inlet hose, Black
EPDM (2 pack)
4 ft (1.2 m) Inlet hose, Black
EPDM (2 pack)
5 ft (1.5 m) Inlet hose, Red and
Blue EPDM (2 pack)
5 ft (1.5 m) Nylon braided inlet
hose (2 pack)
6 ft (1.8 m) Nylon braided inlet
hose, space-saving 90° elbow,
hypro-blue steel couplings (2
pack)
®
Whirlpool Models*
*For additional details (or information) specific to your model, refer
to the 'Dimensions' listed for your model at www.whirlpool.com.
Custom under-counter installation:
1"
(25 mm)
Recessed area or closet installation:
3"
(76 mm)
48 in 2
(310 cm )
2
24 in 2
3"
(155 cm 2 )
(76 mm)
0.25"
(5 mm)
39"
(991 mm)
minimum
1"
(25 mm)
27"
(686 mm)
1"
(25 mm)
1" 1"
(25 mm) (25 mm) (25 mm)
1"