Installation Instructions; Requirements; Tools And Parts - Whirlpool 7MWFC6820LW Owner's Manual

INSTALLATION INSTRUCTIONS

WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
NOTE: To avoid floor damage, set machine onto cardboard before
moving it.
Move All-In-One Washer & Dryer
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from machine.
Move machine to within 4 ft (1.2 m) of its final location. It must be
in a fully upright position.
Locate transport bolts
Locate four transport bolts on rear of machine.
Remove transport bolts from All-In-One Washer &
Dryer
Loosen bolts with a 5/8" (16 mm) wrench.
Remove each bolt from machine, by pulling in the direction of the
arrows, pull bolts and plastic spacers from back of machine.
Discard bolts and spacers.
NOTE: Do not plug machine in until installation has been
completed.

REQUIREMENTS

Tools and Parts

Tools needed:
Adjustable or open end
wrenches 1/2" (13 mm), 5/8"
(16 mm) and 9/16" (14 mm)
Ruler or measuring tape
Optional tool
Flashlight
Parts needed (not supplied with machine):
Water inlet hoses (2)
Parts supplied (not supplied with machine):
NOTE: All parts supplied for installation are in the machine
basket.
Cable tie
Level
Pliers that open to 1 9 / "
16
(39.5 mm)
Bucket
Flat inlet hose washers (4)
Drain hose with clamp and
form (may be shipped
unassembled)
9