HP Kayak xu700 Technical Reference Manual page 73

NOTE
CAUTION:
SCSI devices to connectors 1 and 2.
For information on how to connect internal an external SCSI devices, please
read your User's Guide.
SCSI Cable Information
The intended use of the external SCSI connector is to connect Low-Voltage
Differential SCSI devices to your Personal Workstation. This section
provides you with SCSI cable information that is important for the correct
operation of your external SCSI device.
The total length of the external SCSI cable should not exceed 10 meters
(approximately 32.81 feet) and there must be at least eight inches of cable
separating each device.
Contact you dealer to order shielded HP SCSI cables to connect external
SCSI accessories.
Low-voltage differential SCSI is very sensitive to noise, and therefore, all cables on
the SCSI bus must be exceptionally high quality cables. Examples of these are given
in the following table.
Please make sure that any external hard disk enclosures are rated for low-voltage
differential SCSI use.
Cable Number
C2978A
C2979A
C2911B
C2924B
C2361A
C2362A
C2363A
C2365A
1.
High Density Thumbscrew (HDTS)
2.
Very High Density Cabled Interconnect (VHDCI)
Cable Length Description
0.5m
68-pin HDTS
1.5m
1.0m
2.5m
1.0m
68-pin VHDCI
2.5m
10.0m
5.0m
3 Interface Cards
SCSI Adapter Cards
1
to 68-pin HDTS
2
to 68-pin HDTS
73