HP Kayak xu700 User Manual page 33

16-bit SCSI Terminator
fitted on cable
16-bit Internal U160
68-pin SCSI connector
16-bit SCSI cable with three
68-pin connectors
External 68-pin SCSI connector
accessible from the rear of the PC.
SCSI Card in PCI Slot
Which SCSI
Connectors to Use
NOTE
Before Installing a
SCSI Hard Disk
Cables and Connectors (SCSI Models)
Models with a SCSI card can be connected to up to five internal SCSI
devices.
Additional devices can be added outside the PC by connecting directly to
the rear panel SCSI connector. The SCSI card allows up to 15 devices to be
connected, five internal and ten external SCSI devices.
The total length of the external SCSI cables should not exceed 3 meters
(approximately 10 feet).
If you are installing an additional SCSI drive, you should assign an
unused SCSI ID to this accessory. SCSI IDs range from 0 to 15 for wide
16-bit SCSI.
SCSI ID 0 is used by the first SCSI hard disk drive and SCSI ID 7 is reserved
for the integrated SCSI controller (the default for narrow and wide SCSI
devices).
2 Installing and Replacing Hardware Parts in Your PC Workstation
Secondary IDE cable
Secondary IDE Connector
Primary IDE Connector
Installing Mass Storage Devices
Two IDE data cables each
with two 40-pin connectors
for IDE Drives
Primary IDE cable
Cable with one 34-pin
connector for
3.5-inch Floppy Disk Drive
Floppy Disk Drive Connector
33