HP Kayak xu700 User Manual page 28

Installing or
Replacing a
Memory Module
2 Installing and Replacing Hardware Parts in Your PC Workstation
Removing, Replacing and Upgrading Memory
Removing and Installing a Memory Module
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 25 for instructions).
To ease installation, place the PC on its side with the system board
facing upwards.
3 If you are installing
additional memory
modules then you will
need to remove the
continuity modules. Open
the two retaining clips and
remove the continuity
module from the socket.
If you are replacing an
existing memory module
then open the two
retaining clips and remove the existing memory module the socket
Always store any removed memory or continuity module in a safe place
for future use.
4 Install your new memory
modules, ensuring that
the two notches on the
bottom edge of each
memory module is
aligned with those of the
socket. With the two
retaining clips open,
press the memory
module fully into the socket until the retaining clips click into position
You can also close the retaining clips by hand to ensure that the module
is correctly inserted.
5 Replace the PC Workstation's cover (refer to page 26). Reconnect all the
power and telecommunications cables.
6 Check the Summary Screen to verify the new configuration (refer to
"Viewing the Summary Screen" on page 17)
28
.
.
.