Installing A Second Hard Disk Drive - HP Kayak XM600 Hardware Replacement Manual

Installing a Second Hard Disk Drive

1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front bezel (refer to page 3 for
these instructions).
3 Remove the two retaining screws from the hard disk drive tray located
on the front of the chassis, then carefully slide the tray towards the rear
.
of the PC
4 Insert the new drive into the drive tray and secure it to the tray using the
screw provided with the hard disk drive tray. Only one screw is required.
5 Carefully put the drive tray back into the PC, and secure it in position
using the two retaining screws that you removed earlier.
6 Connect the power cable and the data cable to the rear of the new hard
disk drive. The connectors are shaped to go in one way only. If you
are not sure which connector to use, refer to "Installing Mass Storage
Devices", on page 13.
7 Replace the front bezel and PC Workstation's cover (refer to page 3).
Reconnect all the power and telecommunications cables.
8 Turn to page 25 to complete the installation.
Installing and Replacing Hardware Parts in Your PC Workstation
Installing a Second Hard Disk Drive
17