Removing, Replacing And Upgrading Memory On Models Shipped With Rdram - HP Kayak XM600 Hardware Replacement Manual

Installing and Replacing Hardware Parts in Your PC Workstation

Removing, Replacing and Upgrading Memory on Models Shipped with RDRAM

NOTE
NOTE
Removing, Replacing and Upgrading Memory
on Models Shipped with RDRAM
Upgrading RDRAM Memory
RDRAM models of the HP Kayak XM600 PC Workstation support one or
two RAMBUS Direct RAM (RDRAM) memory modules.
Use only the HP memory modules provided for your PC model. If you want
to find out about available accessories for your PC, refer to the HP
Accessories Web site at: http://www.hp.com/go/pcaccessories.
If only one RDRAM module is installed, it must be installed in the socket
nearest the processor(s).
If two RDRAM modules are installed, they must be installed in the two
sockets nearest the processor(s).
Any unused memory socket must contain a continuity module.
The system board may also have a third memory socket. This socket is
reserved uniquely for the SDRAM Memory Expansion Card supplied with
SDRAM models.
Removing and Replacing an RDRAM Module
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 2 for instructions).
3 Remove the HP UltraFlow Airflow Guide (refer to page 4 for
instructions).
4 To remove a memory module, open the two retaining clips and remove
the module out of the socket
5 To install a module, ensure that the two notches of the memory module
are aligned with those of the socket. With the two retaining clips open,
press the memory module completely into the socket. You hear two
clicks as the retaining clips click into position
6 Replace the HP UltraFlow Airflow Guide (refer to page 4 for
instructions).
7 Replace the PC Workstation's cover (refer to page 3). Reconnect all the
power and telecommunications cables.
10
.
.