Table of Contents
Advertisement
4.2
Step 2: Connect the camera
SC180
Camera
adapter
Microscope
You can connect the camera to the microscope and computer as soon as you've
installed the software. Do the following:
1)
2)
3)
4)
Make sure that the plug is the right way round
ATTENTION
The USB plugs are not symmetrical. Make sure that the plugs are the right way
round when you plug them into the ports.
5)
Remove the camera's protective cap.
Mount the camera onto the microscope's camera adapter.
Plug the end of the USB cable with the type B plug into the camera socket and
tighten the knurled screws. Make sure that you only use the USB cable that is
delivered with your camera. The proper functioning of the camera can only be
guaranteed when this cable is used.
Plug the end of the camera's USB cable with the type A plug into a free USB
3.0 port of your PC. If possible, use a USB 3.0 port that is located on the back
side of your PC.
After connecting the camera to your PC, the camera driver is automatically
installed. As a rule, this installation only takes a few seconds. Please pay
attention to the icons displayed in the status bar.
Wait until the installation of the camera driver has been finished.
4 Installation
Monitor
PC
17
Advertisement
Table of Contents
