Table of Contents
Advertisement
4
www.aeg.com
Before carrying out any maintenance, disconnect the
•
appliance from the power supply.
WARNING: Ensure that the appliance is switched off
•
before replacing the lamp to avoid the possibility of
electric shock.
Do not use the appliance before installing it in the
•
built-in structure.
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal
•
scrapers to clean the glass door since they can scratch
the surface, which may result in shattering of the glass.
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
To remove the shelf supports first pull the front of the
•
shelf support and then the rear end away from the
side walls. Install the shelf supports in the opposite
sequence.
Use only the food sensor (core temperature sensor)
•
recommended for this appliance.
2. SAFETY INSTRUCTIONS
2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not pull the appliance by the
handle.
• Install the appliance in a safe and
suitable place that meets installation
requirements.
• Keep the minimum distance from
other appliances and units.
• Before mounting the appliance, check
if the oven door opens without
restraint.
• The appliance is equipped with an
electric cooling system. It must be
operated with the electric power
supply.
• The built-in unit must meet the
stability requirements of DIN 68930.
Cabinet minimum
height (Cabinet un-
der the worktop mini-
mum height)
Cabinet width
Cabinet depth
Height of the front of
the appliance
600 (600) mm
550 mm
605 (580) mm
594 mm
Advertisement
Table of Contents
