Installation Site; Installation - omi EL 36 Instruction And Maintenance Manual

2.2 INSTALLATION SITE

While preparing a proper site for the installation of the dryer, please take into account the following
requirements
 The machine must be protected from atmospheric agents and not directly exposed to sun light.
 A seating base flat and capable to hold the weight of the machine.
 Ambient temperature complying with the nominal data of the dryer.
 A clean, dry and without forced draft (we suggest to blow the warm air outside the installation site).

Make sure to leave sufficient clearance around the dryer in order to allow an adequate cooling of
the machine and for maintenance and/or control operations
The incoming air must be free from smoke or flammable vapours which could lead to explosion or fire
risks.

2.3 INSTALLATION

Before attempting any installation operation, make sure that
 No parts of system are under pressure.
 No parts of the system are electrically powered.
 Tubing to be connected to the dryer are impurities free.
After having verified the points listed above, you can proceed to the installation of the machine.
1. Connect the dryer to the compressed air lines indicated in the diagrams below. If not already
existing, we suggest to install a by-pass allowing to insulate the machine from the plant, thus to
facilitate eventual maintenance operations.
2. Check the condensate drainage assembly, and connect the drain flexible hose to the draining line,
keeping in mind that the condensate separated by the dryer contains oil particles, therefore,
in order to dispose it in compliance with the local rules in force, we suggest a water-oil
separator having adequate capacity.
3. Power the dryer after having checked that the nominal voltage and line frequency are constant
and matching the nominal values of the machine. The user must provide the installation with
an adequate line protection and a ground terminal complying with the electrical rules
locally in force.
1
Air Compressor
2
Aftercooler
3
Condensate Separator
4
Receiver
5
Automatic Drain
6
Ceramic Prefilter 10μ
7
Dust Filter 5μ
8
Dryer
9
Solenoid drain valve
10
Coalescing Filter 1μ – 0.1 mg/m
11
Coalescing Filter 0.01μ – 0.01 mg/m
12
Activated carbon filter 0.003 mg/m
13
Water/Oil Separator
In order to optimise the use of the dryer, we suggest to place it in such a way that all the control
instruments of the machine will result easily visible.
Installing a ceramic pre-filter on the air inlet of the dryer, this will be better protected from eventual solid
particles, as it prevents the accumulation of oily materials on the heath exchangers.
Cod. 710.0151.01.00 Rev0B – 08.2012
3
3
3
.
ENGLISH
5 - 66