Table of Contents
Advertisement
Getting Started
Solving Minor Problems (Continued)
Problem
Cursor will not move
using the arrow keys
on the keypad.
Blank monitor screen.
20
Cause
The Num Lock key may
be on.
Monitor is not turned on
and the monitor light is
not on.
The cable connections
are not correct.
The energy saver feature
has been enabled.
The RGB (Red, Green,
Blue) input switch on the
monitor is incorrectly set.
You are using a
fixed-sync monitor and it
will not sync at the
resolution chosen.
The VGA/BNC selector
switch is not properly set.
Solution
Press the Num Lock key. The Num
Lock light should not be on if you
want to use the arrow keys.
Turn on the monitor and check that
the monitor light is on.
Check the cable connection from the
monitor to the computer and to the
electrical outlet.
Press any key or click the mouse
button and, if set, type your
password.
Set the monitor's RGB input switch
to 75 ohms and, if there is a sync
switch, set it to external.
Be sure that the monitor can accept
the same sweep rate as the
resolution chosen.
Set the selector switch to agree with
the cable connection.
Quick Setup & Getting Started Guide
Advertisement
Table of Contents
