Table of Contents
Advertisement
Getting Started
Ä
14
I
Turn up the brightness and contrast controls of the monitor if the
monitor is dim.
I
Press and hold any key. If the system beeps, then your keyboard is
operating correctly.
I
Check all cable connections for loose connections or incorrect
connections.
I
Reconfigure your computer after installing a non–plug and play
expansion board or other option. See "Solving Hardware
Installation Problems" for instructions.
I
Be sure that all the needed device drivers have been installed. For
example, if you have connected a printer, you need to install a
printer driver.
I
Take out all diskettes from the diskette drives when you turn on
your system.
CAUTION: When the computer is plugged into an AC power source,
there is always power applied to the system board. You must disconnect
the power cord from the power source before opening the computer to
prevent system board or component damage.
Quick Setup & Getting Started Guide
Advertisement
Table of Contents
