Table of Contents
Advertisement
Keyboard Light Combinations Used by Boot Block ROM
FailSafe Boot Block Mode
Num Lock
Caps Lock
Num, Caps, Scroll Lock
Num, Caps, Scroll Lock
✎
Diagnostic lights do not flash on USB keyboards.
*Insert valid ROMPaq diskette in drive A. Turn power switch off, then on to reflash ROM. If
ROM flash is successful, all three keyboard LEDs will light up and you will hear a rising tone
series of beeps. Remove diskette and turn power off, then on to restart the computer. For
more information about flashing the ROM, refer to the Troubleshooting Guide.
Quick Setup & Getting Started Guide
Color
LED Activity
Green
On
Green
On
Green
Turn on and off 2
times
(accompanied by
1 long and 3 short
beeps)
Green
On
Getting Started
State/Message
ROMPaq diskette not
present, is bad, or drive not
ready.* The screen displays
a Boot Block Recovery
message when using an
embedded graphics
controller.
Enter password.*
ROM flash failed.*
Boot Block ROM Flash
successful. Turn power off,
then on to reboot.
17
Advertisement
Table of Contents
