Maintenance; Troubleshooting; Environmental Protection - Gern Pro DAN0804 Instruction Manual

DAN0804

MAINTENANCE

Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.

TROUBLESHOOTING

1. If your sander will not operate, check the power at the mains plug.
2. If the sander does not abrade surface, checking the sanding paper. If the sanding paper have been worn,
replace the new paper and try again. The paper must be kept in a dry place, if it is allowed to become
damp, the abrasive particles will lose their adhesion to the backing paper and will not abrade.
3. If the sander dose not move smoothly, the sanding paper may be loose, damaged or wrinkled. Replace
and try again.
4. If a fault cannot be rectified return the sander to an authorized dealer for repair.

ENVIRONMENTAL PROTECTION

When disposing of the product's packaging, observe the local instructions given for garbage disposal and
recycling, depending on the material.
The device cannot be disposed of with the ordinary waste, it should be delivered to a separate
waste collection point. More information at www.serty.fi
25