Table of Contents
Advertisement
CABLE CONNECTIONS ARE:
KEI-095 RS-232 (9 Pin) D-Type
2.
From the KEMLOAD directory, type KEMLOAD <CR> on the computer to start the
Kemload program. Press F4 to change the data file name if desired.
3.
From the main menu press the 0 key. The Start Test menu will be displayed. Press the
2 key to enter the Download Menu.
4.
Press the 5 key to begin the data download. If the Download Error message is
displayed, check the cable and be sure the last line of the Kemload Computer screen
reads "Waiting to receive data".
5.
The data will display on the computer screen as it is being received by the computer.
When the download is complete, both the computer and Brake tester will indicate this.
6.
The KEMLOAD program allows the data to be edited before being saved. Press F3 to
edit the file. If the data is to be saved on disk, press the F2 key to save. Data is not
permanently stored on disk until F2 is pressed.
7.
The data remains in the KEI-095 Brake tester memory and can be download as many
times as desired. To clear the memory and reset the pointer to DATA-000, select the
Download menu and press the 9 key to reset memory. There is also a clear memory
command in the System Setup menu. NOTE: Be sure no important data remains in
the Brake tester memory before clearing or resetting it as all data is irretrievably
lost.
8.
Press F10 to exit the KEMLOAD program. Press the Brake tester * key to exit the download
menu.
96-002.doc
47650 CLIPPER DR. PLYMOUTH TWP., MI. 48170 (734) 414-6500
KEMKRAFT
MODEL KEI095/095A BRAKE PEDAL TESTER
Pin 2 (RxD)
Pin 3 (TxD)
Pin 5 (GND)
ENGINEERING, INC.
COMPUTER COM1 (9 Pin) D-Type
Pin 2 (TxD)
Pin 3 (RxD)
Pin 5 (GND)
Page 9 of 9
Revised: 21-AUG-96
Advertisement
Table of Contents
