Table of Contents
Advertisement
Certain system parameters must be modified when changing to a new vehicle or adjustment is
required. The pedal length from pivot point to the middle of the brake pedal must be changed
when switching to a new vehicle.
The clock should be checked for accuracy and reset for daylight savings time.
To enter a new pedal angle:
1.
Turn on the brake tester. Press any key to display the main menu.
2.
Press the 0 key to enter the Start Test menu.
3.
Press the 1 key to change the pedal length.
4.
The display will show the current pedal length. Enter the Four numbers of the new
pedal length on the keyboard. Be sure to enter any leading zeros and the hundreds place
decimal point will be entered automatically.
5.
When the forth number is entered, the display will go back to the Start Test Menu. The
new pedal length is stored in memory and will remain until it is changed again.
To enter a new time and date:
1.
Turn on the brake tester. Press any key to display the main menu.
2.
Press the 2 key to enter the System Setup menu. Press the 1 key to set the time and
date.
3.
The display will show the current time and date.
4.
Press the 1 key to change the time if required.
5.
Enter the new time, in 24 hr format (1:00 pm = 13), on the keypad. Enter a 2 number
hours, 2 number minutes, and 2 number seconds. The display will return to display the
new time.
6.
Press the 0 key to change the date if required.
7.
Enter the new date on the keypad. Enter a 2 number months, 2 number days, and the
last 2 digits of the year. The display will return to display the new date.
8.
Press the * key to return to the System Setup and main menus.
96-002.doc
47650 CLIPPER DR. PLYMOUTH TWP., MI. 48170 (734) 414-6500
KEMKRAFT
MODEL KEI095/095A BRAKE PEDAL TESTER
ENGINEERING, INC.
SYSTEM SETUP
Page 5 of 9
Revised: 21-AUG-96
Advertisement
Table of Contents
