Table of Contents
Advertisement
4.
If the Pedal force transducer is used, place it on the brake pedal and secure it firmly in
place.
5.
Route all transducer cables so that they do not interfere with pedal operation. The
cables must have enough slack to move freely without binding.
6.
Plug the transducer cables and the power cable into the Brake tester. The brake tester
connectors are marked and keyed so no damage can occur from incorrect cable
connection.
7.
Start the car and plug the power cable into the car cigarette lighter.
8.
Turn the Brake Tester on. The start-up screen will be displayed. Press any key to enter
the first menu.
9.
Press the 2 key to enter the system setup menu and press the 2 key again to display the
pedal angles. Do not press the 0 key.
10.
Adjust the pedal and Floor transducers so that their angles read less than +/- 2 degrees.
Adjust the transducer angles by loosening the center thumb screw slightly, adjusting the
transducer, and carefully re-tightening the screw.
The installation is now complete. Press the * key twice to return to the main menu and the
tester is ready to be used.
The operation of the KEI-095 Brake Tester is controlled by various menus. Select the required
operation from the menu using numbers on the keypad. Any entered data is entered on the
keypad. Decimal points are added automatically.
To run a normal test:
1.
Be sure all setup is complete as detailed in the Operation section. Be sure the car is
running. Turn on the Brake Tester power switch. Always start and stop the car with
Brake Tester power off.
2.
Press the 0 key to select START TEST. The Test menu will be displayed. Press the 0
key again to start the test.
3.
A menu screen will display which shows the functions of each of the keys during
testing. Press any key to start the test.
96-002.doc
47650 CLIPPER DR. PLYMOUTH TWP., MI. 48170 (734) 414-6500
KEMKRAFT
MODEL KEI095/095A BRAKE PEDAL TESTER
ENGINEERING, INC.
OPERATION
Page 3 of 9
Revised: 21-AUG-96
Advertisement
Table of Contents
