Figure F-3. Vga Monitorc; Table F-3. Db-15 Monitorc; F.6 Connectors - Compaq Deskpro Workstation AP230 Technical Reference Manual

F.6 CONNECTORS
There are three connectors associated with the graphics subsystem; two display/monitor
connectors and the Feature connector.
NOTE: The graphic card's edge connector mates with the AGP slot connector on the
system board. This interface is described in chapter 4 of this guide.
F.6.1 MONITOR CONNECTOR
The display/monitor connector is provided for connection of a compatible RGB/analog monitor.
Figure F-3. VGA Monitor Connector, (One of two female DB-15, as viewed from rear).
Table F-3. DB-15 Monitor Connector Pinout
Pin Signal
1 R
2 G
3 B
4 NC
5 GND
6 R GND
7 G GND
8 B GND
NOTES:
[1] Fuse automatically resets when excessive load is removed.
5 4 3
10
9 8
15 13
14
Table F-3.
DB-15 Monitor Connector Pinout
Description Pin
Red Analog 9
Blue Analog 10
Green Analog 11
Not Connected 12
Ground 13
Red Analog Ground 14
Green Analog Ground 15
Blue Analog Ground --
Original - November 2000
Technical Reference Guide
2 1
7
6
11
12
Signal Description
PWR +5 VDC (fused) [1]
GND Ground
NC Not Connected
SDA DDC2-B Data
HSync Horizontal Sync
VSync Vertical Sync
SCL DDC2-B Clock
-- --
Compaq Personal Computers F-5