License Plate Bulb Replacement; Headlight Aiming; Fluids And Capacities - Chrysler 2006 Sebring Convertible Owner's Manual

License Plate Bulb Replacement

1. Locate both small slots on the outboard side of the
license lamp. Using a small screwdriver, remove the
entire housing.
2. Turn the bulb socket counterclockwise to remove it
from the housing. Pull the bulb out of the socket. Replace
the bulb and snap it back into place on the housing of the
chrome appliqué.

Headlight Aiming

The headlights on your new vehicle were aimed at the
factory. The factory setting was made at a no load setting.
A great increase in weight will change the aiming and it
may be necessary to readjust the headlights if carrying an
excessive amount of weight in the trunk, rear seats or
pulling a trailer. To readjust the headlights first mark the
position of the headlights on a wall prior to loading the
vehicle. Load the vehicle and then readjust the headlights
to the original position. If any further adjustments are
necessary contact your manufacturer's dealer. A detailed
service procedure is contained in the manufacturer's
Service Manual. Information on purchasing a Service
Manual can be found at the back of this Owner's Manual.
MAINTAINING YOUR VEHICLE 257

FLUIDS AND CAPACITIES

Fuel (approximate)
2.4 and 2.7 Liter Engines (87 Oc-
tane)
Engine Oil-With Filter
2.4 and 2.7 Liter Engines (Refer
to the engine oil fill cap for the
correct SAE grade)
Cooling System *
2.4 Liter Engines* (Mopar
Antifreeze/Coolant 5 Year/
100,000 Mile Formula) or
equivalent.
2.7 Liter Engines (Mopar
Antifreeze/Coolant 5 Year/
100,000 Mile Formula) or
equivalent.
* Includes 1 qt. for coolant tank.
U.S. Metric
16 Gal- 61 Liters
lons
5 qts. 4.7 Li-
ters
8 qts. 7.5 Li-
ters
7
9.5 qts. 9.0 Li-
ters