Table Of Contents; Introduction - Husqvarna FS 600 E Operator's Manual

Introduction..................................................................... 2
Safety..............................................................................6
Operation...................................................................... 12
Maintenance................................................................. 22
Troubleshooting............................................................ 25
Owner responsibility
WARNING:
stone by methods such as cutting, grinding
or drilling, especially during dry operation,
generates dust that comes from the material
being processed, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability
to breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders
wear appropriate respiratory protection such
as dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
2
Contents

Introduction

Processing of concrete and
Transportation, storage and disposal........................... 26
Technical data.............................................................. 27
Accessories.................................................................. 29
Supplier's declaration of Conformity............................. 30
To minimize dust emissions, use water to
bind the dust, when feasible.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
• The product's safety instructions.
• The product's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
Product description
The product is an electrical walk behind floor saw.
Intended use
This product is used with diamond blades for wet cutting
to cut hard floor surface materials such as concrete,
asphalt and stone. All other use is incorrect.
The product is used in industrial operations by operators
with experience.
Do not use outdoors or in wet conditions, this product is
for indoor use only.
1620 - 003 - 28.02.2022