Handle Adjustment - Swisher Trim-N-Mow Owner's Manual

Assembly
Contents of Box:
• Trimmer
• Parts bag containing:
• Manual
• Engine manual
• Safety goggles
• Bottle of engine oil
• 4 sets of .155 trimmer line
• Cable Clip
Tools Required:
• ½" wrench
Installation of handles:
• Remove loose fasteners from lower handles.
• Pivot handles up and align lower hole in handles with hole on trimmer frame. Install
hardware removed in previous step. Snug, but do not tighten bolts.
• Pivot upper handles to fit the lower handles. Tighten knobs.
• Adjust handles for comfortable operation.
• Tighten all bolts.
Handles may be adjusted up and down and in and out for comfortable operation.
Installation Of Wheels
Refer to Page 12 for illustration.
• Slide axle through the mounting plates.
• Install Conical springs with the large diameter side against the Axle Plate.
• Install Flat Washer against the conical spring.
• Slip wheel on one side and install Cotter Pin.
• Bend cotter pin over to prevent it from falling out.
• Push the Axle completely over to the other side.
• Install the second wheel and insert cotter pin and bend. Some compression of the
conical springs is necessary .
All manuals and user guides at all-guides.com
6

Handle Adjustment