Assembly; Handle Adjustment; Installation Of Wheels - Swisher ST60022Q Owner's Manual

Assembly

Contents of Box:
· Trimmer
· Parts bag containing:
· M anual
· Engine manual
· Safety goggles
· Bottle of engine oil
· 4 sets of .155 trimmer line
Tools Required:
· ½" wrench
Installation of handles
· Remove loose fasteners from lower handles.
· Pivot handles up and align lower hole in handles with hole on trimmer frame. Install
hardware removed in previous step. Snug, but do not tighten bolts.
· Pivot upper handles to fit the lower handles. Tighten knobs.
· Adjust handles for comfortable operation.
· Tighten all bolts.
Handles may be adjusted up and down and in and out for comfortable operation.

Installation Of Wheels

Refer to Page 12 for illustration.
•Slide axle through the mounting plates.
•Install Conical springs with the large diameter side against the Axle Plate.
•Install Flat Washer against the conical spring.
•Slip wheel on one side and install Cotter Pin.
•Bend cotter pin over to prevent it from falling out.
•Push the Axle completely over to the other side.
•Install the second wheel and insert cotter pin and bend. Some compression of the conical springs is
necessary .
www.SmallEngineDiscount.com
6
Need Parts

Handle Adjustment