Configuring The Sound Effect Manager (6-Connector) - HP Compaq Presario,Presario SR1010 Getting Started Manual

The previous figure shows the six audio connectors arranged on the back of the PC:
the four connectors (A, B, C, and E) used for eight-channel audio and the
connectors for the microphone (D, mic) and the audio line in (F, in).
Connecting the speaker system to the PC (6-connector)
1 With the speaker system off, assemble the speakers and, if used, the subwoofer.
Refer to the speaker documentation.
2 Turn off the PC.
3 Connect the audio cable plugs from the speaker system subwoofer to the
connectors on the back of the PC. (See the following table.)
Connect speaker cable (plug) for:
Front speakers (or two stereo speakers)
Side speakers
Rear speakers
Center speaker/subwoofer
4 Turn on the PC.
5 Turn on the speaker system.
6 Configure the audio output for this 6-connector multi-channel speaker system by
performing the following procedure.
Configuring the Sound Effect Manager
(6-connector)
1 Click Start on the taskbar.
2 Choose Control Panel.
3 If it is present, click Sounds, Speech, and Audio Devices.
4 Click Sound Effect Manager. The window opens.
5 Click the Speaker Configuration button.
6 Select the option describing the number of speakers in your system, for
example, 7.1 speakers.
A connector with no descriptive text in the Connection Guide indicates that the
connector is not used for the selected speaker configuration.
You can click the Speaker Test button to test the speakers.
NOTE:
7 Click OK.
To PC port (label, name,
color):
Audio line out (E, out, lime green)
Side speaker (A, side, gray)
Rear speaker (B, rear, black)
Center speaker/subwoofer
(C, c/sub, gold)
Setting Up Sound
15