Table of Contents
Advertisement
Section 1: Assembly & Set-Up
Unhook Quick Hitch From Implement
!
DANGER
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
implement. Keep people and animals away while backing-up
to the implement or pulling away from the implement. Do not
operate hydraulic controls while a person or animal is directly
behind the power machine or near the implement.
1.
If implement has a parking stand, raise implement off
the ground slightly higher than what is needed to set
parking stand to support implement.
2. Without changing the 3-point arm height, shut tractor
down according to "Tractor Shutdown Procedure"
on page 11.
3. If applicable, set parking stand to support implement.
4. Restart tractor and lower implement to ground.
5. Shut tractor down according to "Tractor Shutdown
Procedure" on page 11.
6. If applicable, unhook driveline safety chain from
tractor and pull driveline yoke from tractor power
take-off shaft.
7.
Disconnect floating top link as follows:
•
If floating top link is used only with this implement,
remove hairpin cotter and hitch pin connecting
floating top link to the Quick Hitch.
•
If floating top link will be used on other implements,
remove hairpin cotter, hitch pin, and bushing
connecting floating top link to the implement.
Bushing not included with QH20 floating top link.
8. Reinstall hardware in floating top link for storage.
9. Move Quick Hitch release levers/handles as follows:
•
QH05: Move release levers to locking notches as
shown in Figure 1-10. Make sure levers are
retained by the locking notches.
•
QH16, QH20 & QH30: Rotate release handles up
as shown in Figure 1-11.
10. Restart tractor and lower 3-point lift arms until auto-
lock hooks are below implement hitch pins and upper
hook is below implement upper hitch point.
11. Slowly drive tractor forward several feet while
watching to make sure Quick Hitch does not catch on
implement while pulling away.
12. Shut tractor down according to "Tractor Shutdown
Procedure" on page 11.
13. Store driveline off the ground. See implement
Operator's Manual for detailed instructions.
14. If floating top link will not be used with another Quick
Hitch hook-up, remove hairpin cotter and hitch pin
connecting floating top link to the Quick Hitch.
15. Reinstall removed hardware in floating top link. Store
floating top link in a location where it can be easily
located later.
7/15/22
Table of Contents
w
Release Lever
Locking Notch
QH05 Shown With Handles Secured In Locking Notches
Release Handle
QH05, QH16, QH20, & QH30 Quick Hitches 320-003M
Figure 1-10
QH16, QH20 QH30
With Handles Rotated Up
Figure 1-11
37126
17294
19
Advertisement
Table of Contents
